Stack Exchange

Gil

top accounts reputation activity subscriptions
Top Questions
No questions with score of 5 or more
Top Answers
30
Best way to store very small amount of data?
electronics.stackexchange.com

22
Second counter saved in flash memory - How to avoid deterioration?
electronics.stackexchange.com

21
Is it normal for expanding foam insulation to contain air bubbles?
diy.stackexchange.com

17
Is paralleling MOSFETs a good or a bad idea?
electronics.stackexchange.com

13
Can I use multiple BJT transistors in parallel if a single one can't carry enough current?
electronics.stackexchange.com

12
How do I fix an outlet where the junction box falls into the hole and the wires are too short?
diy.stackexchange.com

12
How to find electric device(s) driving a high electric bill?
diy.stackexchange.com

12
Closing a hole from removed tap head after replacing it with mixer
diy.stackexchange.com

11
Gas furnace takes like 2-5 minutes from ignition to blower start. flame also burning yellow/orange
diy.stackexchange.com

11
Can I cover an outlet with homemade 3D-printed covers?
diy.stackexchange.com

11
Center of a wire nut holding neutral wires is burned, but it doesn't seem loose
diy.stackexchange.com

11
Minor damage to house wire insulation for dishwasher
diy.stackexchange.com

10
What is this small cubic device in my recessed light housing?
diy.stackexchange.com

10
How can I drill my own electrical knockout?
diy.stackexchange.com

9
How do I remove electrical box knockouts without spot welds?
diy.stackexchange.com

8
How to drain a toilet bowl?
diy.stackexchange.com

8
Can lead-acid batteries be stored by removing the liquid from them?
electronics.stackexchange.com

8
Why do car blinkers flash at twice the speed when a blinker light has burned out
electronics.stackexchange.com

8
555 monostable configuration: why shorting a charged capacitor is not a concern?
electronics.stackexchange.com

7
How should I repair a hole cut into a heating duct?
diy.stackexchange.com

7
Voltage rating of a Zener diode
electronics.stackexchange.com

7
How to replace bearings on a multimeter knob?
diy.stackexchange.com

7
Why do typical DC motors use brush contacts rather than just conductors?
electronics.stackexchange.com

6
Why are there loops of copper water pipe coming out of my concrete floor?
diy.stackexchange.com

6
Will a spark gap transmit a signal an FM receiver can "hear?"
electronics.stackexchange.com

6
Measuring AC voltage at the panel - why avoid measuring from neutral?
diy.stackexchange.com

6
In I2C communication, slave not able to pull down properly during 9th clock pulse (not giving proper ack)
electronics.stackexchange.com

6
What's the cheapest way to wire these lights that are 400' away at the end of the driveway?
diy.stackexchange.com

6
Can you leave empty space in the middle of an electrical panel or do the breakers need to be installed contiguously?
diy.stackexchange.com

6
Cable standard for data and power
electronics.stackexchange.com

1 2