Stack Exchange

Hearth

Electrical engineering graduate student at the University of Alabama.

Autistic, 20-something, here to hopefully be able to help people.

top accounts reputation activity bookmarks subscriptions
Top Questions
Top Answers
39
Why are multimeter batteries awkward to replace?
electronics.stackexchange.com

32
What is the difference between a linear regulator and an LDO
electronics.stackexchange.com

30
What does n/o and n/c mean on a schematic diagram?
electronics.stackexchange.com

30
What does the multimeter dial do internally?
electronics.stackexchange.com

24
Why does my MOSFET always burn?
electronics.stackexchange.com

24
What is the purpose of oscilloscope-probe-to-BNC adapters?
electronics.stackexchange.com

23
Is negative resistance possible?
electronics.stackexchange.com

22
Why do relays, solenoids, and motors have a DC voltage across them if they're inductors?
electronics.stackexchange.com

21
What are these round pads on the bottom of a PCB?
electronics.stackexchange.com

20
What's the point in a preamp?
electronics.stackexchange.com

19
What are the correct specs for an SNES power supply?
gaming.stackexchange.com

19
Is a lawful good "antagonist" effective?
writing.stackexchange.com

18
What is the difference between a negative linear regulator and a positive one?
electronics.stackexchange.com

17
Which is a better conductor, a very thick rubber wire or a very thin copper wire?
electronics.stackexchange.com

16
What can I do about using incorrect P-FET package?
electronics.stackexchange.com

15
Symbol identification (J?)
electronics.stackexchange.com

15
Construction for a homogeneous field using permanent magnets
electronics.stackexchange.com

15
Why aren't resistors being used in this flip-flop used in static MOS RAM?
electronics.stackexchange.com

13
Connector type for a plug-in short-circuit
electronics.stackexchange.com

13
Audio Jack Safety 230v DC
electronics.stackexchange.com

13
Ring around wire on diagram
electronics.stackexchange.com

13
Is it normal to have 3.3 V in the heat pad of a LD1117V33C linear regulator (TO-220)?
electronics.stackexchange.com

13
Why is the air gap between the stator and rotor on a motor kept as small as it is?
electronics.stackexchange.com

12
KiCAD: Cannot see traces on a PCB side which has been filled with copper
electronics.stackexchange.com

12
Should a ferrite bead be placed close to the MCU or close to the power supply?
electronics.stackexchange.com

11
How does Vivi differ from other Black Mages?
gaming.stackexchange.com

11
Is this an acceptable way to create +/-5V from +/-12V?
electronics.stackexchange.com

11
Identify Vintage Power Cord for 1980s Organ
electronics.stackexchange.com

11
Is this power supply universal input voltage?
electronics.stackexchange.com

11
Why is USB Type-A to USB Type-A never used?
electronics.stackexchange.com

1 2 3 4