Stack Exchange

Michael Karas

Oregon

http://www.carousel-design.com

top accounts reputation activity favorites subscriptions

Top Questions

Stars Make Stars

code-golf ascii-art asked Apr 14 at 14:49

codegolf.stackexchange.com

Using smooth dowel pegs

glue dowel asked Mar 18 '15 at 15:09

woodworking.stackexchange.com

How to keep dust-free when digitizing photos

technology glass dust asked Mar 11 '15 at 0:34

lifehacks.stackexchange.com

Toilet Seat Style

toilet usa seat asked Feb 3 at 2:04

diy.stackexchange.com

How do I find the water main entry point to my house?

valve shutoff locating asked Feb 14 '13 at 7:14

diy.stackexchange.com

Correct Method to Nail Casing Corners

casing trim asked Mar 18 '15 at 13:56

woodworking.stackexchange.com

How to Reduce Hissing, Fighting and Aggression Between Two Cats

cats aggression bonding asked Oct 20 '14 at 4:09

pets.stackexchange.com

What is the best way to mount a LiPo battery in a project box?

batteries lipo enclosure asked Oct 28 '18 at 19:17

electronics.stackexchange.com

Top Answers

Is it OK to lie to a customer to protect them from themselves?

workplace.stackexchange.com

Should a washer go on nut side, or the bolt side?

diy.stackexchange.com

How can I close a gap between my fence and my neighbor's that's on his side of the property line?

diy.stackexchange.com

How to avoid stripping screw heads?

diy.stackexchange.com

Why does music synthesizer built from chain of astable multivibrator circuits get “out-of-tune” after a few hours?

electronics.stackexchange.com

Is it okay for my boss to answer my personal and/or work cell without permission?

workplace.stackexchange.com

Mysterious cord running from wall. Safe?

diy.stackexchange.com

Can I reduce voltage from 3.3V to 1.8V using a 1.5V battery?

electronics.stackexchange.com

Firmware protection on AVR and PIC controllers

electronics.stackexchange.com

How to create measurement points on a PCB for diagnostics?

electronics.stackexchange.com

What is this 3.5mm plug designed for?

electronics.stackexchange.com

Why did the capacitor blow up?

electronics.stackexchange.com

Why is serial EEPROM preferred over parallel EEPROM?

electronics.stackexchange.com

Why would a switch be wired with its neutral connected to ground?

diy.stackexchange.com

Safe/professional way to transport lumber with just a roof rack

diy.stackexchange.com

Is acetone or isopropyl alcohol better for removing Rosin flux?

electronics.stackexchange.com

Do LEDs require more power to function as they age?

electronics.stackexchange.com

How do you solder something big?

electronics.stackexchange.com

What is this silver component?

electronics.stackexchange.com

What should be done before using a fireplace that has not been used in decades?

diy.stackexchange.com

Can I cause damage to electrical appliances by unplugging them when they are turned on?

diy.stackexchange.com

How can I fill a screw hole so it can be used again?

diy.stackexchange.com

In earlier tape recorders, how was tape spool angular velocity adjusted?

electronics.stackexchange.com

Is it a good idea to connect a line buffer to ground?

electronics.stackexchange.com

How does factory reset work?

electronics.stackexchange.com

Reasons not to use these leads

electronics.stackexchange.com

Do buck converters increase the amp hours of a battery?

electronics.stackexchange.com

Does a roof with 3 layers of asphalt shingles somehow last longer?

diy.stackexchange.com

Why does my drill bit destroy the screw head?

diy.stackexchange.com

How can I cut off the rusted closet bolts holding my toilet?

diy.stackexchange.com