Stack Exchange

Matt Young

Indianapolis, IN, USA

US based electronics engineer

top accounts reputation activity bookmarks subscriptions
Top Questions
Top Answers
42
Why would an op-amp use BJTs over MOSFETs?
electronics.stackexchange.com

29
Reverse polarity protection
electronics.stackexchange.com

27
Why must Integrated Circuits be baked (in the oven) before being used on a prototype board?
electronics.stackexchange.com

22
Why use a "load switch" and not just one transistor as a switch
electronics.stackexchange.com

22
What's the usage of these holes?
electronics.stackexchange.com

19
User safety for battery powerd device against misuse of power supply
electronics.stackexchange.com

16
What is the component on the schematic indicated by the symbol of a diagonal rectangle with a line through it?
electronics.stackexchange.com

16
How does soldering affect the internal bonding between the IC die and its package?
electronics.stackexchange.com

15
What does this Mosfet Symbol mean (two diodes facing each other at Vgs)?
electronics.stackexchange.com

14
Why are two stages used for an instrumentation amplifier?
electronics.stackexchange.com

14
What are abbreviations used in electrical engineering?
electronics.stackexchange.com

13
Any good solutions for dealing with resistors for color-deficient tinkerers?
electronics.stackexchange.com

13
Why don't more devices incorporate full-wave rectifiers as reverse polarity protection?
electronics.stackexchange.com

13
Fuse position in relation to load and switch
electronics.stackexchange.com

12
4 layer PCBs with Fritzing
electronics.stackexchange.com

12
Options for soldering a through hole PCB (e.g. Teensy) flush/flat on another PCB
electronics.stackexchange.com

12
What are abbreviations used in electrical engineering?
electronics.stackexchange.com

11
Why do I have to use the same ground?
electronics.stackexchange.com

11
Can a 10% resistor be used as a 1% resistor?
electronics.stackexchange.com

11
Is it OK for traces to come off SMD pads at the corners?
electronics.stackexchange.com

11
What are the ways to make a dual power supply from a single voltage source?
electronics.stackexchange.com

10
Not understanding why my resistor R4 for the circuit schematic is reading 35k ohms on a multimeter when its meant to be 47k ohms?
electronics.stackexchange.com

10
What is the use of analog circuits today?
electronics.stackexchange.com

9
Ways to isolate DC power source
electronics.stackexchange.com

9
Why might the collector-emitter voltage for this transistor be so high?
electronics.stackexchange.com

9
What are abbreviations used in electrical engineering?
electronics.stackexchange.com

9
New to PCB design - why doesn't auto placing components exist?
electronics.stackexchange.com

9
16-bit or 24-bit converters?
electronics.stackexchange.com

9
Completely different circuit response with 1000kΩ than with 1MΩ resistance
electronics.stackexchange.com

8
What temperature should I keep my home at for my cat's comfort?
pets.stackexchange.com

1 2 3